Mã lỗi Ricoh Aficio SPC420DN — Trang 5/15
Code:
Tất cả lỗi (113)
195
202
203
204
205
210
211
212
213
220
222
224
226
230
231
232
233
234
235
236
237
240
241
242
243
270
300
301
302
303
304
305
306
307
325
360
361
362
363
364
365
366
367
368
369
370
371
372
373
374
375
380
396
397
400
418
442
452
490
491
531
532
541
542
543
544
545
547
557
559
636
670
687
690
818
819
820
821
822
823
824
826
827
828
829
851
853
854
855
856
857
860
861
863
864
865
866
867
868
870
872
873
874
875
876
877
900
920
921
990
991
992
998
Description: Charge AC bias error [C] The charge current less than 200 mkA is detected.
Causes: Defective charge roller. Defective connectors. Disconnected harness. Defective high voltage power 1.
Remedy: 1. Check the connectors. 2. Replace the PCU for cyan. 3. Replace the drum positioning plate. 4. Replace the high voltage power 1.
Description: Charge AC bias error [Y] The charge current less than 200 mkA is detected.
Causes: Defective charge roller. Defective connectors. Disconnected harness. Defective high voltage power 1.
Remedy: 1. Check the connectors. 2. Replace the PCU for yellow. 3. Replace the drum positioning plate. 4. Replace the high voltage power 1.
Description: Color development motor error LOCK signal is not detected for more than two seconds while the motor START signal is on. LOCK signal is not cancelled within two seconds after the motor is off.
Causes: Color development motor slip due to the increase of the load torque
Remedy: 1. Adjust the load torque properly by replacing or cleaning the development unit. 2. Replace or repair the development motor if the load torque is normal
Description: TD sensor: Output maximum error [K] Vt is more than the maximum value (4.5) for three times consecutively.
Causes: Defective connector connection. Increasing toner density.
Remedy: 1. Replace the PCU.
Description: TD sensor: Output maximum error [M] Vt is more than the maximum value (4.5) for three times consecutively.
Causes: Defective connector connection. Increasing toner density.
Remedy: 1. Replace the PCU.
Description: TD sensor: Output maximum error [C] Vt is more than the maximum value (4.5) for three times consecutively.
Causes: Defective connector connection. Increasing toner density.
Remedy: 1. Replace the PCU.
Description: TD sensor: Output maximum error [Y] Vt is more than the maximum value (4.5) for three times consecutively.
Causes: Defective connector connection. Increasing toner density.
Remedy: 1. Replace the PCU.
Description: TD sensor: Output minimum error [K] Vt is less than the minimum value (0.5) for three times consecutively.
Causes: Defective connector connection. Decreasing toner density
Remedy: 1. Replace the PCU.