Description: Paper position sensor slide motor error The paper position sensor moves but is not detected at the home position within the specified time. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
Causes: • Motor harness disconnected, loose, defective • Defective motor
Remedy: 1. Check the connections to the paper position sensor slide motor. 2. Replace the paper position sensor slide motor.
Description: Fold unit bottom fence motor error The bottom fence of the fold unit moves but is not detected at the home position within the specified time. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
Causes: • Motor harness disconnected, loose, defective • Defective motor
Remedy: 1. Check the connections to the fold unit bottom fence motor. 2. Defective fold unit bottom fence motor.
Description: Stacking sponge roller motor error The sponge roller moves but is not detected at the home position within the specified time. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
Causes: • Motor harness disconnected, loose, defective • Defective motor
Remedy: 1. Check the connections to the stacking sponge roller motor. 2. Defective stacking sponge roller motor.
Description: Stack junction gate motor error The stack junction gate moves but is not detected at the home position within the specified time. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
Causes: • Motor harness disconnected, loose, defective • Defective motor
Remedy: 1. Check the connections to the stack junction gate motor. 2. Defective stack junction gate.
Description: Boot loader error The boot loader cannot read one of the following: self-diagnostic module, kernel, or one of the files of the root file system, or the check of one of these items on the system SD card failed.
Causes: • File or module on the system SD card is corrupted • File or module on the system SD card is illegal • Make sure that the system SD card is the one designed for the machine • Replace controller board.