• Code: F1-06
• Description: Offset motor trouble
  When the offset motor of the finisher is driven it does not reach the specified position.
• Causes: Offset motor abnormality Offset motor origin sensor abnormality Finisher PWB abnormality
• Remedy: (AR-FN5A) Use SIM 3-3-6 to check the offset motor operation (AR-F14N) Use SIM 3-3-6 to check the slide motor operation

• Code: F1-08
• Description: Staple motor error
  The staple motor cannot return to the home position.
• Causes: Staple motor abnormality Staple motor home position sensor abnormality Staple unit abnormality Finisher PWB abnormality
• Remedy: Use SIM 3-3-7 to check the staple motor operation

• Code: F1-10
• Description: Staple motor trouble
  Staple motor operation abnormality
• Causes: Motor lock. Motor rpm abnormality. Overcurrent to the motor. Finisher control PWB trouble.
• Remedy: Use SIM 3-3-5 to check the staple motor operation

• Code: F1-11
• Description: Rear edge plate home position error
  The rear edge plate cannot return to the home position.
• Causes: Rear edge plate drive motor abnormality Side guide plate home position sensor abnormality Finisher PWB abnormality
• Remedy: (AR-FN5A) Use SIM 3-3-2 to check the rear edge plate motor operation (AR-F14N) Use SIM 3-3-9 to check the bundle exit motor operation

• Code: F1-15
• Description: Finisher lift-up motor trouble
  The finisher lift-up motor does not reach the specified position.
• Causes: Lift-up motor abnormality Lift-up motor upper limit sensor abnormality Finisher PWB abnormality
• Remedy: Use SIM 3-3-5 to check the lift-up motor operation

• Code: F1-19
• Description: Alignment motor (F) trouble
  Alignment motor operation abnormality
• Causes: Motor lock. Motor rpm abnormality. Overcurrent to the motor. Finisher control PWB trouble.
• Remedy: Use SIM3-3-8 to check the alignment (F) motor operation.

• Code: F1-20
• Description: Alignment motor (R) trouble
  Alignment motor operation abnormality
• Causes: Motor lock. Motor rpm abnormality. Overcurrent to the motor. Finisher control PWB trouble.
• Remedy: Use SIM3-3-7 to check the alignment (R) motor operation

• Code: F1-30
• Description: Finisher interface error
  Communication line test error occurs when power is turned on or after the exit of a simulation mode. Error in console finisher communication
• Causes: Connection trouble or disconnection of the connector and harness between the body and the finisher. Finisher control PWB trouble. Control PWB (PCU) failure. Malfunction by noises.
• Remedy: Canceled by turning OFF/ON the power. Check the connectors and the harness of communication line Replace the finisher control PWB.