Description: The analog to digital converter appears to be bad. Try reseating the printhead data cable. Then reseat the main board. If the problem continues try replacing the main board and then the printhead.
Description: The drum temperature is incorrect as sensed by the drum thermistor. Ensure that there is adequate clearance for airflow (at least 4 inches (10 cms.) on all sides) and that the room temperature is within specification.
Description: The drum heater is running away. Unplug the printer NOW! Verify that the vent on the right side of the printer is not blocked. Ensure that the drum fan rotates and is installed correctly.
Description: Most likely cause is a failed drum heater. The head to drum gap should only be checked or adjusted on the Phaser 840. The Phaser 850 and 860 have a pre-adjusted head.
Description: The preheater temperature is incorrect as sensed by the a thermistor in the preheater. Ensure that there is adequate clearance for airflow (at least 4 inches (10 cms.) on all sides) and that the room temperature is correct.
Description: The preheater thermistor appears to be open. Check the preheater cables on the right side of the printer. Replace the paper preheater. Replace the power supply.