Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Xerox Phaser 840 — Trang 12/13

Code: 6,001.42

Display: 6,001.42
Description: Indication that the motor coil(s) is open or shorted, or the X-axis motor fuse has opened. Follow the procedure "Testing motor and solenoid resistances", on page 84 of this manual. Try diagnostics to verify X-axis movement. If there is not any movement, it is propable that the fuse is defective. The fuse is located in the power control board; the whole baord should be replaced.

Code: 6,002.43

Display: 6,002.43
Description: Indication that the motor coil(s) is open or shorted, or the X-axis motor fuse has opened. Follow the procedure "Testing motor and solenoid resistances", on page 84 of this manual. Try diagnostics to verify X-axis movement. If there is not any movement, it is propable that the fuse is defective. The fuse is located in the power control board; the whole baord should be replaced.

Code: 6,003.44

Display: 6,003.44
Description: Indication that the motor coil(s) is open or shorted, or the X-axis motor fuse has opened. Follow the procedure "Testing motor and solenoid resistances", on page 84 of this manual. Try diagnostics to verify X-axis movement. If there is not any movement, it is propable that the fuse is defective. The fuse is located in the power control board; the whole baord should be replaced.

Code: 6,033.66

Display: 6,033.66 XA_PROGFAULT_X6
Description: XA Unexpected Message. The XA task received an unexpected ITC message while in the idle state.

Code: 7,035.63

Display: 7,035.63: PM_PROG_FAULT_ FUNCS(3)
Description: Negative delay in pm_sleep_for(). A negative delay argument was passed to pm_sleep_for().

Code: 7,036.64

Display: 7,036.64: PM_PROG_FAULT_ FUNCS(4)
Description: Unexpected message in pm_sleep_for(). An unexpected ITC message was received by pm_get_message() during processing of pm_sleep_for().

Code: 7,052.62

Display: 7,052.62: PM_PROG_FAULT_ FUNCS(20)
Description: Bad message ID in pm_update_dmc_status(). The ITC message received and passed to pm_update_dmc status() did not match any DMC status message that the Process Motor task was expecting.

Code: 8,002.67

Display: 8,002.67 CAP_PROG_FAULT(22)
Description: Generic Cap Task Program Fault. This error indicates that the main CAP state sequencer, cap_main(), has entered the program fault state. There are multiple reasons that this can happen. Genereally they involve unexpected conditions while performing CAP movements; home, goto, etc.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie