Description: The preheater is not heating at all, or is not heating as quickly as it should. Check for an open connection. Replace the paper preheater. Replace the power supply.
Description: An inalid reading is being reported by the preheater thermistor. Verify the connections to the paper preheater, replace the paper preheater, replace the main board, and then replace the power control board.
Description: Occurs during the scales and offset calibration. Any part in the chain could be responsible for the incorrect reading including the printhead electronics, the A/D electronics, the waveform generation electronics, power supply, wave amplifier (on the power control board), printhead interconnect cable.
Description: Occurs when the printer is attempting to determine how many data taps the printhead uses. Any part in the chain may be responsible for the reading, including the printhead electronics, the A/D electronics, the waveform generation electronics, power supply, wave amplifier (on the power control board), and printhead interconnect cable.