• Code: E000-0000
• Description: The heater fails to heat. After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR)
  After power-on, the reading of the main thermistor does not increase to 70 deg C or higher within 20 sec.
• Remedy: - Replace the main/shutter thermistor. - Replace the DC controller PCB.

• Code: E000-0010
• Description: The heater fails to heat. After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR)
  The power has been turned off and then on without resetting the error.
• Remedy: - Reset the error. (COPIER>FUNCTION>CLEAR>ERR)

• Code: E001-0001
• Description: There is an abnormal rise in temperature. After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR)
  There is an error or an open circuit in the main thermistor, shutter thermistor, or sub thermistor.
• Remedy: - Check the connector of each thermistor for any fault in connection and wiring. - Replace the thermistor in question. - Replace the DC controller PCB.

• Code: E001-0002
• Description: There is an abnormal rise in temperature. After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR)
  The reading of the main thermistor, shutter thermistor, or sub thermistor is 230 deg C or higher for 2 sec.
• Remedy: - Replace the thermistor in question. - Replace the DC controller PCB.

• Code: E001-0003
• Description: There is an abnormal rise in temperature. After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR)
  The reading is not 150 deg C or higher or 210 deg C or lower within 30 sec.
• Remedy: -Cheak the connecting of the main/ sub/ shutter thermistors. -Check the mounting of the main/ sub/ shutter thermistors. -Exchange the main/ sub/ shutter thermistors. -Exchange the DC controller PCB.

• Code: E001-0010
• Description: There is an abnormal rise in temperature. After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR)
  The power has been turned off and then back on without resetting the error.
• Remedy: - Reset the error. (COPIER>FUNCTION>CLEAR>ERR)

• Code: E002-0000
• Description: There is an abnormal rise in temperature. After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR)
  The reading of the main thermistor is not 100 deg C 12 sec after it has exceeded 70 deg C.
• Remedy: - Check the connector of the main/shutter thermistor for any fault in connection and wiring. - Check the main/shutter thermistor for mounting condition. - Replace the main/shutter thermistor. - Replace the fixing heater unit. - Replace the DC controller PCB.

• Code: E002-0001
• Description: There is an abnormal rise in temperature. After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR)
  The reading of the main thermistor is not 150 deg C 15 sec after it has exceeded 100 deg C.
• Remedy: - Check the connector of the main/shutter thermistor for any fault in connection and wiring. - Check the main/shutter thermistor for mounting condition. - Replace the main/shutter thermistor. - Replace the fixing heater unit. - Replace the DC controller PCB.