Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Canon NP8580

Code: E000

Description: The temperature of the upper fixing roller has not increased above the specified level 90 seconds after switching power on. The temperature of the upper fixing roller does not reach 150 C within 8 minutes after switching power ON. The temperature of the upper fixing roller does not reach 180 C within 5 minutes of reaching 150 C. The temperature of the upper fixing roller drops below 50 C during STANDBY.

Code: E001

Description: The temperature of the upper fixing roller exceeds 250 C.

Code: E005

Description: The length of fixing assembly cleaning belt wound on the take-up reel exceeds the specified length.

Code: E010

Description: When two or more clock pulses are not inputted for a period of 2 seconds after a MAIN MOTOR DRIVE command is generated.

Code: E011

Description: When excessive current is detected by the fault detection circuit of the DC driver PCB. When excessive current is detected by the fault detection circuit of the duplexing unit driver PCB. When excessive current is detected by the fault detection circuit of the scanner motor driver PCB.

Code: E020

Description: When a toner out signal (TSP) is emitted from the developing assembly for a total of at least two minutes.

Code: E050

Description: When the HOLDING TRAY HOME POSITION signal (THP) is not generated within 4 seconds from the beginning of HOLDING TRAY MOTOR DRIVE command (TMDP1,2) When the HOLDING TRAY HOME POSITION signal (THP) is generated for at least one second while the HOLDING TRAY MOTOR DRIVE command (TMDSP1,2) is being generated.

Code: E203

Description: When two or more clock pulses are not inputted from the SCANNER MOTOR DRIVE command is being generated.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie