• Code: 0001
• Description: Internal RAM
  The read/write of the RAM on the Main PCA was diagnosed and an error was detected.
• Remedy: • Replace the Main PCA

• Code: 0002
• Description: SRAM
  The read/write of the SRAM on the Main PCA was diagnosed and an error was detected.
• Remedy: • Replace the Main PCA

• Code: 0004
• Description: Flash ROM
  The program area in the Flash ROM is sum-checked, and it could not be read, causing an error.
• Remedy: • Reinstall the Firmware (Printer and Boot Firmware). • If the Error continues, replace the Main PCA

• Code: 0008
• Description: PIO
  The read/write of a specific Parallel I/O (PIO) was tested and an error was detected.
• Remedy: • Replace the Main PCA

• Code: 0010
• Description: NVRAM
  Problems with the NVRAM detected.
• Remedy: • If multiple errors have occurred that include the NVRAM error, try to resolve the other errors first. After resolving the other errors (except NVRAM), switch the Printer Off. • Switch the Printer On again and only the NVRAM error recovery will be performed. • If System Error Code 11Ax appears when the Printer is turned On. • Replace NVRAM • Replace Main PCA

• Code: 0020
• Description: FPGA (Main PCA)
  The read/write of the FPGA-ATG (Band Memory) and FPGA-RSM (Mask Memory) registers on the Main PCA was diagnosed and an error was detected.
• Remedy: • Replace the Main PCA

• Code: 0040
• Description: FPGA (Carriage PCA)
  The read/write of the FPGA-PTC (Print Timing Controller) and FPGA-PDD (Print Data Distributor) registers on the Carriage PCA was diagnosed and an error was detected.
• Remedy: • Replace the Carriage PCA • Make sure that the Carriage Cable is correctly connected. • Replace the Main PCA

• Code: 0080
• Description: ASIC CONF (Main PCA)
  The program load from the Flash ROM on the Main PCA to the FPGA on the Main PCA or sum-check was not performed correctly and an error occurred.
• Remedy: • Reload the ASIC program from the IC Card. • Replace the Main PCA