Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi HP DesignJet 10000s — Trang 7/7

Code: H05

Description: Center Heater Temperature Error
Temperature read by the Center Heater is abnormal (lower than -10C or higher than 70C).
Remedy: • Make sure that the Heater Relay Assembly is connected correctly to the Center Platen. • Replace the Heater Relay Assembly • Replace the Center Platen

Code: H06

Description: Front Heater Time-out Error
The temperature of the Front Heater does not reach the preset temperature even after 15 minutes.
Remedy: • Make sure that the Voltage alternation switch located at the back of the Printer is set correctly to the AC voltage being used. • Make sure that the Fuse (F2) on the Heater Relay Assembly has not blown. If the fuse has blown, replace it. • Make sure that the Heater Board is connected correctly to the Relay Board via the Relay Cable. • Make sure that the Heater Relay Assembly is connected correctly to the Front Heater. • Replace the Heater Relay Assembly • Replace the Front Heater

Code: H07

Description: Rear Heater Time-out Error
The temperature of the Rear Heater does not reach the preset temperature even after 15 minutes.
Remedy: • Make sure that the Voltage alternation switch located at the back of the Printer is set correctly to the AC voltage being used. • Make sure that the Fuse (F2) on the Heater Relay Assembly has not blown. If the fuse has blown, replace it. • Make sure that the Heater Board is connected correctly to the Relay Board via the Relay Cable. • Make sure that the Heater Relay Assembly is connected correctly to the Rear Heater. • Replace the Heater Relay Assembly • Replace the Rear Heater

Code: H08

Description: Center Heater Time-out Error
The temperature of the Center Heater does not reach the preset temperature even after 15 minutes.
Remedy: • Make sure that the Voltage alternation switch located at the back of the Printer is set correctly to the AC voltage being used. • Make sure that the Fuse (F2) on the Heater Relay Assembly has not blown. If the fuse has blown, replace it. • Make sure that the Heater Board is connected correctly to the Relay Board via the Relay Cable. • Make sure that the Heater Relay Assembly is connected correctly to the Center Platen. • Replace the Heater Relay Assembly • Replace the Center Platen Heater

Code: H09

Description: Operation Panel Switch Error
The specified switch is not pressed for 30 seconds or more when the diagnostics that verifies the switch action is executed.
Remedy: • Replace the Heater Relay Assembly

Code: H10

Description: Zero Cross Error
This error occurs when the diagnostics for the AC Relay is executed.
Remedy: • Make sure that the Heater Board is connected correctly to the relays on the Heater Block Assembly • Make sure that the Heater Board is connected correctly to the Relay Board via the Relay Cable. • Replace the Heater Relay Assembly
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie