Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi HP DesignJet 10000s — Trang 5/7

Code: 1270

Description: Feed Motor Error
Over-current problem in the Feed Motor Drive Circuit.
Remedy: • Check the short-circuit of the internal cable of the Feed/Rewind Motor and Feed Motor Relay Cable. • Check the short-circuit of the Feed Motor. • Replace the Add-On (HEB2) Control PCA

Code: 1280

Description: Take-Up-Reel Motor Error
Over-current problem in the Take-Up-Reel Motor Drive Circuit.
Remedy: • Check the short-circuit of the internal cable of the Feed/Take-Up-Reel Motor and Take-Up-Reel Motor Relay Cable. • Check the short-circuit of the Take-Up-Reel Motor. • Replace the Add-On (HEB2) Control PCA

Code: 1290

Description: End of Life of Part Reached
The end of life of the Prime Assembly has been reached since it has been working for more than 58 hours.
Remedy: • Replace the Prime Assembly . Page 8-121.

Code: 12Ax

Description: End of Life of Part Reached
The end of life of the Pump Tube has been reached since it has been working for more than 73 hours.
Remedy: • Replace the Ink Pump Assembly

Code: 170X

Description: Servo Motor Error
The Paper-Axis or the Scan-Axis Motor moves the Carriage, but the input from the Linear Encoder Sensor does not change. x = 0: Feed System. x = 1: Carriage System. x = 2: Servo Unit.
Remedy: • Make sure that there is no paper jam blocking the Carriage path. • Make sure that the corresponding cables are connected correctly to Connectors CN14 and CN17 on the Main PCA. • Make sure that the Linear Encoder Sensor Cable is connected correctly to the Carriage PCA. • Make sure that the Encoder Strip is not damaged or scratched. • Make sure that the pinchwheels rotate correctly. • Make sure that the Carriage gears work correctly • Replace the Main PCA • If the error continues, replace the Paper-Axis or Scan-Axis Motors.

Code: 2000

Description: Add-On (HEB2) Control PCA
Problems with the Add-On (HEB2) Control PCA detected.
Remedy: • Make sure the HEB2 Board Interface Cable is connected correctly and is not damaged • Replace the Add-On (HEB2) Control PCA • If the error continues, replace the Main PCA

Code: 4000

Description: Cap Position Adjustment Value
This error appears when the Cap Position Adjustment Value is set to zero.
Remedy: • To clear this error: – Turn the Printer ON in error skip mode by holding down the Cancel and Shift keys and pressing the ON button. – Enter the Password to enter the Maintenance Mode menu: Shift and OK. – Set the correct Cap Position value (so that it is not set at 0.0 mm)

Code: F_es: 0001

Description: Operation Code Exception
Remedy: 1. Replace the Main PCA . 2. Upgrade the Printer Firmware.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie