Code :

Code: 40.00.02
Description: Embedded I/O buffer overflow To continue, touch “OK”. The product has experienced a JetDirect buffer overflow.
Remedy: 1. Touch the OK button to print the transferred date (some data might be lost). 2. Check the host configuration.

Code: 40.00.03
Description: EIO <X> buffer overflow To continue, touch “OK”. Too much data was sent to the EIO card in the specified slot (x). An incorrect communications protocol might be in use.
Remedy: Touch the OK button to print the transferred date (some data might be lost).

Code: 40.00.04
Description: EIO <X> bad transmission To continue, touch “OK”. The connection between the product and the USB device has been broken.
Remedy: 1. Touch the OK button to clear the error message and continue printing. 2. Remove, and then reinstall the USB device.

Code: 40.00.05
Description: Embedded I/O bad transmission To continue, touch “OK”. The USB device has been removed.
Remedy: 1. Touch the OK button to clear the error message (data will be lost). 2. Install the USB device.

Code: 40.08.0X
Description: USB storage accessory removed. X = 0 or ;1 information code. Secure file erase is enabled.
Remedy: No action necessary.

Code: 40.0X.05
Description: USB storage accessory removed. X = 1, 2, 3, 5, or 6; information code. The USB storage accessory was removed.
Remedy: No action necessary.

Code: 41.03.YZ
Description: Unexpected size in tray <X>. The product detected a different paper size than expected. Y = Type, Z = Tray • Y = 0 Size mismatch. Detected media is longer or shorter than expected. • Y = A Size mismatch. Detected media too long. • Y = B Size mismatch. Detected media too short. • Y = C Size mismatch. Inter-page gap error. • Z = D Source is the duplexer. • Z = 1 Source is Tray 1. • Z = 2 Source is Tray 2. • Z = 3 Source is Tray 3.
Remedy: 1. Touch OK to use another tray. 2. Make sure that the tray is loaded with the correct paper size and that the sliding paper guides are correctly adjusted. 3. Use the Tray/Bin manual sensor test to verify that the cassette media switch is correctly functioning. 4. If the issue persists, replace the Mech kit.

Code: 42.XX.YY
Description: Error Event Log message. Internal system failure.
Remedy: 1. Turn the product off, then on, and then retry. 2. If the error persists, clear the firmware image from the active partition by using the Partial Clean item in the Preboot menu.