• Code: 003-349
• Description: Send error detected by Controller Sending under runESPIPE
• Causes: Power OFF and ON

• Code: 003-350
• Description: Varieties of errors detected by Controller EIO
• Causes: Power OFF and ON

• Code: 003-354
• Description: Parity error is caused in receiving a status from IOT
• Causes: It is caused when receiving NAK which reporting the communication fail. Check the connection of HVPS/MCU connect harness. If the trouble is still caused, replace HVPS/MCU PWB.

• Code: 003-356
• Description: Overrun is caused in receiving a status from IOT
• Causes: It is caused when receiving NAK which reporting the communication fail.Check the connection of HVPS/MCU connect harness. If the trouble is still caused, replace HVPS/MCU PWB.

• Code: 003-360
• Description: Initialization error between IOT-ESS
• Causes: Fail to initialize IOT (MCU). Check the connection of HVPS/MCU connect harness. Replace HVPS/MCU PWB.

• Code: 003-362
• Description: PAGE-SYNC is caused before the preparation of video output is completed.
• Causes: PageSync becomes active before writing output data until buffer becomes full when printing. Replace the harness to connect ESS and IOT. Replace ESS PWB.

• Code: 003-363
• Description: PAGE-SYNC finish error in outputting video
• Causes: PageSync becomes inactive before the specified size is printed out when printing. Replace the harness to connect ESS and IOT. Replace ESS PWB

• Code: 003-364
• Description: DMA transfer error
• Causes: Compression/decompress is not finished though the specified data is input when compressing or decompressing. Insert and remove RAM on ESS PWB (if it exists) Execute the DC355 DIAG test, and replace HDD if the trouble is not recovered. Replace ESS PWB.