• Code: 134
• Display: Service call
  134: Error
• Description: LED head detection abnormality
• Remedy: Is the LED head installed correctly? Does LED HEAD FUSE cut? Does the error recur?
  Install the LED head correctly Check LED HEAD FUSE Replace FUSE Turn on the power supply gain Replace the LED head unit Please refer to chapter 7.6 for replace method of FUSE Replace 86M board

• Code: 153
• Display: Service call
  153: Error
• Description: Defective fuse cutting of ID unit
• Remedy: Is the ID unit installed correctly? Does the error recur? Does the error recur?
  Installed ID unit again Turn on the power supply again Replace 86M board after check the connector connection of high voltage power supply. Replace 86M board.

• Code: 163
• Display: Service call
  163: Error
• Description: Defective toner sensor detection. It does not occur during shipping setting
• Remedy: Is the toner cartridge installed? Is the lock level of toner set? Does the error recur? Does the error recur? Does the error recur?
  Install a toner cartridge. Turn the lock lever of toner cartridge to the fixed position. Remove the right side cover, take measures to prevent the right side of the device from being exposed to ambient light, and confirm that the toner sensor is lighted during initialization of the device. Reconfirm it after replacing the toner sensor Assy. Replace the 86M board.

• Code: 167
• Display: Service call
  167: Error
• Description: Thermistor Slope Error
• Remedy: Is the error message displayed? Does the error recur?
  Turn on the power supply again Turn on the power supply again after storage for 30 minutes.

• Code: 168
• Display: Service call
  168: Error
• Description: Compensation. Thermistor Error
• Remedy: Is the error message displayed? Does the error recur?
  Turn on the power supply again Turn on the power supply again after storage for 30 minutes.

• Code: 169
• Display: Service call
  169: Error
• Description: Upper Side Thermistor Error
• Remedy: Is the error message displayed? Does the error recur?
  Turn on the power supply again Turn on the power supply again after storage for 30 minutes.

• Code: 170, 171
• Display: Service call
  170: Error
  171: Error
• Description: Thermistor Short circuit / Open circuit of the fuser is detected
• Remedy: Is the thermistor connector normally inserted in the CN2 connector of the high-voltage power/ sensor board? • No Insert the Thermistor connector correctly. • Yes Is the heater connector normally inserted in the CN1 connector of the low-voltage power. • No Insert the heater connector appropriately. • Yes Is the heater ON when turning on the power? • No Replace the fuser unit Assy, low-voltage power or main board. • Yes Replace the fuser unti Assy or the main board.

• Code: 172, 173
• Display: Service call
  172: Error
  173: Error
• Description: Thermistor Temperature abnormality (high or low) of the fuser is detected
• Remedy: Is the thermistor connector normally inserted in the CN2 connector of the high-voltage power/ sensor board? • No Insert the Thermistor connector correctly. • Yes Is the heater connector normally inserted in the CN1 connector of the low-voltage power. • No Insert the heater connector appropriately. • Yes Is the heater ON when turning on the power? • No Replace the fuser unit Assy, low-voltage power or main board. • Yes Replace the fuser unti Assy or the main board.