Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 2090 — Trang 9/21

Code: SC541

Description: Fusing Thermistor Open
The fusing temperature detected by the thermistor was below 7°C for 15 s.
Causes: • Fusing thermistor defective or out of position • Poor thermistor terminal connection

Code: SC542

Description: Fusing Temperature Warm-up Error
One of the following occurred: • Hot roller did not reach target operation temperature within 6 minutes after the machine was powered or 6 minutes after the doors were closed. • Fusing temperature rose only 5oC toward the fusing temperature within 20 s after the machine was powered on, or after the doors were closed. • Fusing temperature rose only 5oC toward the fusing temperature within 25 s of the start of hot roller rotation.
Causes: • Fusing lamp(s) disconnected • Thermistor out of position

Code: SC543

Description: Fusing Overheat Error 1: Software
A fusing temperature of over 210°C is detected for 5 s by the fusing thermistor. This prevents the fusing lamps from switching on without a fusing lamp trigger signal.
Causes: • AC drive board defective • BCU defective • Reload the BCU firmware

Code: SC544

Description: Fusing Overheat Error 2: Hardware
The fusing temperature monitoring circuit detects abnormal fusing temperature.
Causes: • AC drive board defective • BCU defective • Reload the BCU firmware

Code: SC545

Description: Fusing Overheat Error 3: Continuous Lamp On After warm-up and while the hot roller is not rotating, the fusing lamps remain on at full power for 90 s.
Causes: • Fusing thermistor out of position • One or more fusing lamp is disconnected

Code: SC546

Description: Fusing Temperature Unstable
The fusing temperature continues to fluctuate rapidly.
Causes: • Poor thermistor connector connection • Poor fusing unit connection

Code: SC547

Description: Zero Cross Signal Malfunction
The applied bandwidth is detected above 66 Hz or below 45 Hz, and no zero-cross signal detected for 5 s with the power relay ON.
Causes: • Noise on the ac power line

Code: SC550

Description: Oil Supply/Cleaning Web End
The oil supply/cleaning web end sensor stays on longer than the specified time after the web motor remains ON for 40 s.
Causes: • Oil supply/cleaning web end (web on supply roller used up) • Oil supply/cleaning web motor defective NOTE: SP1902 001 (Web Motor Control . Web Consumption) should be set to .0. every time the oil supply/cleaning web is replaced. This setting will not take effect until the machine is cycled off/on.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie