Mã lỗi Ricoh Aficio 480W — Trang 11/12
Code:
Tất cả lỗi (94)
SC143
SC191
SC300
SC303
SC305
SC345
SC347
SC350
SC351
SC352
SC353
SC354
SC401
SC411
SC440
SC503
SC504
SC506
SC507
SC531
SC532
SC533
SC534
SC535
SC541
SC542
SC543
SC544
SC545
SC546
SC547
SC549
SC591
SC592
SC593
SC594
SC595
SC596
SC630
SC632
SC633
SC634
SC635
SC670
SC672
SC818
SC819
SC820
SC821
SC822
SC823
SC824
SC826
SC827
SC828
SC829
SC838
SC850
SC851
SC853
SC854
SC855
SC856
SC857
SC860
SC861
SC863
SC864
SC865
SC866
SC867
SC868
SC870
SC873
SC874
SC875
SC880
SC900
SC901
SC910 … SC914
SC919
SC920
SC921
SC925
SC954
SC955
SC964
SC965
SC967
SC990
SC991
SC992
SC997
SC998
Description: External controller down
Causes: • Turn the machine off. • Check the I/F cable to determine if it became disconnected during operation. • Turn the machine on.
Description: Printer error 1
An internal application error was detected and operation cannot continue.
Causes: • Software defective; turn the machine off/on, or change the controller firmware • Insufficient memory
Description: Printer error 2
When the application started, the necessary font was not on the SD card.
Causes: • Font not on the SC card
Description: Net File function error
Causes: • Refer to the four procedures below
Description: Printer Image Setting Error
The IPU did not issue the signal required to start image processing for the printing mode within 60 s after the paper stops for registration.
Causes: • Software defective • Replace the software (all firmware modules). • IPU defective
Description: Memory Setting Error
Settings required for memory to start image processing are not sent from the IPU within 60 s after the paper stops for paper stops for registration
Causes: • Software defective. Replace the software (all firmware modules). • IPU defective
Description: Scanner start signal error 1
The scanner receives another start signal after scanning has already started.
Causes: • Software defective. • Replace the software (all firmware modules).
Description: Print start signal error 2
The printer received another print start signal after print job has already started.
Causes: • Software defective. • Replace the software (all firmware modules).