Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio CL4000DN — Trang 7/16

Code: 373

Description: TD sensor: Initial adjustment error [M] [D] Vt is not (A ± 0.2) when initial setting for TD sensor is executed. A = SP3011-002 for [M]
Causes: • Defective connector connection • Defective TD sensor • The toner density in the developer is different from the initial condition.
Remedy: 1. Replace the PCU.

Code: 374

Description: TD sensor: Initial adjustment error [C]: [D] Vt is not (A ± 0.2) when initial setting for TD sensor is executed. A = SP3011-003 for [C]
Causes: • Defective connector connection • Defective TD sensor • The toner density in the developer is different from the initial condition.
Remedy: 1. Replace the PCU.

Code: 375

Description: TD sensor: Initial adjustment error [Y]: [D] Vt is not (A ± 0.2) when initial setting for TD sensor is executed. A = SP3011-004 for [Y]
Causes: • Defective connector connection • Defective TD sensor • The toner density in the developer is different from the initial condition.
Remedy: 1. Replace the PCU.

Code: 380

Description: Drum gear position sensor error [C] When receiving the input signal of drum gear position sensor is not correctly done, SC380 is logged.
Causes: • Unclean or defective drum gear position sensor
Remedy: 1 Clean the drum gear position sensor. 2 Replace the drive unit.

Code: 396

Description: Drum motor error [K] [D] The LOCK signal is not detected for 2 seconds more while the start signal of the drum motor for black PCU is output.
Causes: • OPC motor slip due to the excessive load
Remedy: 1. Clean the PCU. 2. Check the cable from the Black OPC/ Development motor. Replace it if necessary. 3. Replace the EGB. 4. Replace the Black OPC/ Development motor.

Code: 397

Description: Drum motor error [CMY] [D] The LOCK signal is not detected for 2 seconds more while the start signal of the drum motor for color PCU is output.
Causes: • OPC motor slip due to the excessive load
Remedy: 1. Clean the PCU. 2. Check the cable from the Black OPC/ Development motor. Replace it if necessary. 3. Replace the EGB. 4. Replace the Black OPC/ Development motor.

Code: 400

Description: ID sensor correction error [D] Regular Vsp is not (4 ± 0.5 V) when ID sensor correction is executed.
Causes: • Defective ID sensors • Dirty ID sensors or transfer belt • ID sensor life is over.
Remedy: 1. Replace the ID sensors.

Code: 418

Description: ID sensor: LED adjustment error [D] LED PWM adjustment is not [A] for three times consecutively. [A] = 50 < [A] < 400
Causes: • Defective ID sensors • Dirty ID sensors or transfer belt • ID sensor life is over.
Remedy: 1. Replace the ID sensors.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie