• Code: 562
• Description: Pressure roller temperature error
  The temperature of the pressure roller does not reach the ready temperature for 120 seconds after the fusing lamp has turned on.
• Causes: • Defective thermistor • Defective fusing lamp
• Remedy: 1. Replace the thermistor for the pressure roller. 2. Replace the fusing lamp.

• Code: 563
• Description: Pressure roller overheat 3 (software error)
  The detected pressure roller temperature stays at 215°C or more for 1 second.
• Causes: • Defective PSU • Defective IOB • Defective BCU
• Remedy: 1. Replace the PSU. 2. Replace the IOB. 3. Replace the BCU.

• Code: 564
• Description: Pressure roller overheat 3 (hardware error)
  The thermistor detects 220°C or more
• Causes: • Defective PSU • Defective IOB • Defective BCU • Defective fusing control system
• Remedy: 1. Replace the PSU. 2. Replace the IOB. 3. Replace the BCU.

• Code: 565
• Description: Pressure roller fusing lamp consecutive full power 3
  When the fusing unit is not running in the ready condition, the pressure roller fusing lamp keeps ON full power for 180 seconds or more.
• Causes: • Broken pressure roller fusing lamp
• Remedy: 1. Replace the pressure roller lamp. 2. Replace the PSU.

• Code: 580
• Description: IH inverter zero cross frequency error
  The zero cross signal is not detected for 1 second or more after the IH inverter has turned on.
• Causes: • Disconnected CN983 on the IH inverter • Defective IH inverter • Defective IH coil unit
• Remedy: 1. Check CN983 on the IH inverter. 2. Replace the IH inverter. 3. Replace the IH coil unit.

• Code: 581
• Description: IH inverter input voltage error The IH inverter detects 70V or less/140V or more for 10 seconds.
• Causes: • Unusual input voltage • Disconnected CN981 on the IH inverter • Defective IH inverter
• Remedy: 1. Check CN981 on the IH inverter. 2. Replace the IH inverter.

• Code: 582
• Description: IH inverter current error at power on
  The output current from the IH inverter does not reach the proper value when the IH inverter turns on.
• Causes: • Disconnected power input terminal 1 and 2 • Defective IH inverter • Defective IH coil unit • Defective fusing unit
• Remedy: 1. Check the power input terminals 1 and 2. 2. Replace the IH inverter. 3. Replace the IH coil unit. 4. Replace the fusing unit.

• Code: 583
• Description: IH inverter communication error
  The IH inverter does not get the communication signal from the IOB.
• Causes: • Broken connection between IH inverter and IOB • Defective IH inverter • Defective IOB • Defective BCU
• Remedy: 1. Check the connection between IH inverter and IOB 2. Replace the IH inverter. 3. Replace the IOB. 4. Replace the BCU.