Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio SP6430DN — Trang 4/18

Code: SC542-02

Description: Fusing lamp (Center) thermistor not reloaded 2 The heater (Center) thermistor does not reach the reload temperature 50 seconds after the start of motor rotation.
Causes: • Fusing lamp Disconnected • The over temperature prevention mechanism started working
Remedy: Clear the SP: fusing SC.

Code: SC543-00

Description: Fusing (Center) thermopile high-temperature detected (software) The temperature is detected to stay at 245°C or higher for one second.
Causes: • Shorted triac • Failed the engine board
Remedy: Clear the SP: fusing SC.

Code: SC544-00

Description: Fusing (Center) thermopile high-temperature detected (hardware) The hardware high-temperature error Sensor flag is detected.
Causes: • Damaged triac (shorted) • Failed the engine board • Failed fusing thermistor • Abnormal fusing control software behavior
Remedy: • Clear the SP: fusing SC. • Replace PSU when triac is blown. • Replace engine board and/or fusing thermistor.

Code: SC545-00

Description: Fusing (Center) heater stay ON The thermistor (center) has not detected the target temperature, even after the fusing heater stays ON for more than 30 seconds after reloading.
Causes: • Deformed or floating thermistor • Broken fusing lamp wire • The overtemperature prevention mechanism started working.
Remedy: Clear the SP: fusing SC.

Code: SC547-01

Description: Zero-crossing error (adhered relay contact) When the fusing relay is in an OFF state, a "zero-crossing interrupt request" occurs in 50 ms.
Causes: Damaged fusing relay (adhered contact) Failed fusing relay driving circuit
Remedy: • Turn the main power off/on. • Replace the PSU when fusing relay is broken. • Check the connection between PSU – engine board. • Replace the board and/or harness

Code: SC547-02

Description: Zero-crossing error (bad relay contact) If a "zero-crossing interrupt request" does not occur when the fusing relay is in an ON state, an error results.
Causes: • Damaged fusing relay (open contact) • Failed fusing relay drive circuit • PSU fuse (24VS) blown
Remedy: • Turn the main power off/on. • Replace the PSU when fusing relay is broken. • Check the connection between PSU – engine board. • Replace the board and/or harness. • Replace the PSU fuse (24VS) if it is blown

Code: SC547-03

Description: Zero-crossing error (low frequency error) The number of zero-crossing interrupts does not reach a certain value in 500 ms.
Causes: The frequency of the commercial power supply line is unstable.
Remedy: • Turn the main power off/on. • Check the connection of commercial power supply line • Check the connection between PSU – engine board. • Replace the board and/or harness

Code: SC551-00

Description: Thermistor broken (Edge) While a fusing heater works, temperatures of -20°C or less during a consecutive 9 seconds are detected more than 10 times.
Causes: • Thermistor broken • Connector contact failure
Remedy: Clear the SP: fusing SC
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie