Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio SP8200DN — Trang 6/14

Code: 553

Description: Fusing overheat error 1 (software detection)
A fusing temperature (at the end) of over 230°C (446°F) is detected for 1 second by the fusing thermistors at the center or at either end of the fusing roller.
Causes: • Power supply unit defective • I/O board (IOB) defective • BICU defective • TRIAC short on PSU (PSU defective)

Code: 554

Description: Fusing overheat error 1 (hardware detection)
A fusing temperature (at the end) over 250°C is detected by the fusing temperature monitor circuit in the BICU board.
Causes: • I/O board (IOB) defective • BICU defective

Code: 555

Description: Fusing lamp consecutive full power 1
After warm-up, the fusing lamp remains at full power for 15 seconds without the hot roller rotating.
Causes: • Disconnected or defective thermistors (ends) • Defective fusing lamp

Code: 557

Description: Zero cross frequency error
When the zero cross signal is 66 or more and it is detected 10 times or more in 11 detections, the machine determines that input 60 Hz and SC557 occurs.
Causes: • Noise (High frequency)

Code: 559

Description: Fusing unit jam
The fusing sensor detected a fusing unit paper late jam three times. The paper was late and the fusing exit sensor could not detect the paper three times.
Causes: • Remove the paper that is stopped in the fusing unit. • Check that the fusing unit is clean and has no obstacles in the paper feed path. • If the error persists, replace the fusing unit.

Code: 610

Description: Mechanical counter error: BK
This SC is only for NA models. The machine detects the mechanical counter error when SP5987-001 is set to 1
Causes: • Disconnected mechanical counter • Defective mechanical counter

Code: 621

Description: Communication timeout error between IOB and finisher or mailbox
A break (low) signal is received from the finisher or the mailbox.
Causes: • Disconnected cable • Defective IOB • Defective main board in the peripherals

Code: 622

Description: Paper feed unit communication error
While the IOB communicates with a peripheral, an SC code is displayed if one of following conditions occurs. • The IOB receives the break signal which is generated by the peripheral only just after the main switch is turned on. • The IOB receives the break signal which is generated by URAT.
Causes: • Defective main control board of the peripheral • Defective BCU or IOB • Disconnected peripheral
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie