Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio SPC730DN — Trang 2/15

Code: 231-04

Description: FGATE: Does not turn OFF Y
GPIO has not been negated, although the specified time (200 ms) elapsed after detecting GPIO*assert and then reaching the expected FGATE negate time. * This is an I/O pin. Such I/O pins can be used for a variety of applications, depending on the setting.
Causes: • Control Board • Engine Board
Remedy:

Code: 270-00

Description: Write ASIC communication error
• When the Engine Board could not read the Unique ID of the Writing ASIC properly when starting this machine. • When an Error bit occurred in the communication between the Engine Board and the Writing ASIC.
Causes: The unique ID of the write ASIC was not read normally.
Remedy:

Code: 277-01

Description: LEDA communication errore Board Bk
The head type data was read three times in succession
Causes: • LED Head error • Harness Error
Remedy: • Turn the power OFF and then ON. • Replace the LED Head

Code: 277-02

Description: LEDA communication errore Board C
The head type data was read three times in succession
Causes: • LED Head error • Harness Error
Remedy: • Turn the power OFF and then ON. • Replace the LED Head

Code: 277-03

Description: LEDA communication errore Board M
The head type data was read three times in succession
Causes: • LED Head error • Harness Error
Remedy: • Turn the power OFF and then ON. • Replace the LED Head

Code: 277-04

Description: LEDA communication errore Board Y
The head type data was read three times in succession
Causes: • LED Head error • Harness Error
Remedy: • Turn the power OFF and then ON. • Replace the LED Head

Code: 332-01

Description: Toner supply feed lock Bk
Under the condition that the Toner Cartridge has not reached the end, an error that no toner is supplied has been detected over n times in succession. n: The value was set at SP3-131-015.
Causes: • Disconnected or broken Solenoid: Upper cover. (Failed to open the toner supply shutter) • Disconnection of Toner Supply Clutch • Failed PCDU. (Toner leak) • Toner clogging
Remedy: • Check the connector connection or check for broken wire. • Replace the Solenoid: Upper Cover • Replace the PCDU • Replace the Toner Cartridge.

Code: 332-02

Description: Toner supply feed lock C
Under the condition that the Toner Cartridge has not reached the end, an error that no toner is supplied has been detected over n times in succession. n: The value was set at SP3-131-015.
Causes: • Disconnected or broken Solenoid: Upper cover. (Failed to open the toner supply shutter) • Disconnection of Toner Supply Clutch • Failed PCDU. (Toner leak) • Toner clogging
Remedy: • Check the connector connection or check for broken wire. • Replace the Solenoid: Upper Cover • Replace the PCDU • Replace the Toner Cartridge.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie