Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh M124 SPC830DN — Trang 20/24

Code: 840

Description: EEPROM access error
During the I/O processing, reading error is occurred. The 3rd reading failure issues this SC code. During the I/O processing, writing error is occurred.
Causes: Defective EEPROM
Remedy:

Code: 841

Description: EEPROM read error
Mirrored data of the EEPROM is different from the original data in EEPROM.
Causes: Data in the EEPROM is overwritten for some reason.
Remedy:

Code: 842

Description: Nand-Flash updating verification erro
A writing error for the module written in Nand-Flash occurs when the remote ROM and ROM are updating.
Causes: Damaged Nand-Flash
Remedy: Turn the main switch off and on.

Code: 853

Description: Bluetooth device connection error
(The Bluetooth interface unit was installed while the machine was turned on.) The Bluetooth interface unit was installed while the machine was turned on.
Causes:
Remedy: Turn off the main power switch, and then confirm that the Bluetooth interface unit was installed correctly. And then, turn on the main power switch again.

Code: 854

Description: Bluetooth device removed
(The Bluetooth interface unit was removed while the machine was turned on.) The Bluetooth interface unit was removed while the machine was turned on.
Causes:
Remedy: Turn off the main power switch, and then confirm that the Bluetooth interface unit was installed correctly. And then, turn on the main power switch again.

Code: 855

Description: Hardware Problem: wireless LAN board
The wireless LAN board can be accessed, but an error was detected.
Causes: Loose connection. Defective wireless LAN card.
Remedy: • Make sure that the Wireless LAN connection is good. • Replace the wireless LAN card.

Code: 857

Description: USB IF error
USB I/F cannot be used due to a driver problem.
Causes: An error has occurred to the USB driver.
Remedy: • Make sure that the USB connection is good. • Replace the controller board.

Code: 858

Description: Data encryption conversion error (1)
Causes: -01 A serious error has occurred during the data conversion performed for updating the key for data encryption. • The data in the USB flash drive is damaged. • A communication error has occurred due to electromagnetic waves or other noise. • Replace the controller board. * However, if it is "-30", the machine may recover by turning the main power switch off and then back on. -02 A Data encryption conversion error (2) A serious error occurs when data is encrypted to update an encryption key. Defective NVRAM Replace the controller board. -30 A Data encryption conversion error (3) A recoverable error has occurred before starting data conversion. Defective NVRAM • Turn the main switch off and on. • If the error reoccurs, replace the controller board. -31 A A serious error occurs while the data is encrypted. Same as SC991 Same as SC991
Remedy:
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie