Code :

Code: 01-000
Display: Door is open or Check Transfer belt
Description: Front cover or top cover is opened.
Causes: 1. Harness is defective, Connector is not connected properly. 2. Sensor is defective.

Code: 01-004
Display: Paper Jam in MP tray
Description: The paper from the MP tray has not reached to the feed sensor within a predetermined period of time after pick up.
Causes: 1. Pickup roller rubber is worn out. 2. Pickup Clutch does not work. 3. Feed Sensor is defective.

Code: 01-005
Display: Paper jam in tray 1
Description: The paper from the tray1 has not reached to a feed sensor within a predetermined period of time after pick up.
Causes: 1. Pickup roller rubber is worn out. 2. Pickup Clutch does not work. 3. Feed Sensor is defective.

Code: 01-006, 01-018
Display: Paper jam in tray 2
Description: The paper from the tray2 has not reached to a feed sensor within a predetermined period of time after pick up.
Causes: 1. Pickup roller rubber is worn out. 2. Pickup Clutch does not work. 3. Feed Sensor is defective.

Code: 01-009
Display: Paper jam inside of machine
Description: Paper jam inside of machine 1. At Power On, the paper is jamming at Regi sensor or Feed sensor. 2. At printing, the paper is detecting at Regi sensor or Feed sensor continuously. 3. At printing, the paper is not detected at exit sensor within a predetermined time.
Causes: 1. Feed sensor or Regi Sensor is defective. 2. Exit sensor is defective. 3. Feed Clutch is defective. 4. Regi Clutch is defective.

Code: 01-010
Display: Paper jam in exit area
Description: Paper jam in exit area
Causes: There is paper jammed under the Exit Sensor at Power ON, or the Fuser Actuator Arm, or Exit Sensor is defective.

Code: 01-015
Display: Paper jam at the top of duplex path
Description: 1. At Power On, if the Fuser Exit Sensor and/or Reverse Sensor detects paper. 2. At Printing, Fuser Exit sensor and Reverse Sensor is not on within a predetermined time after paper moves into the Reverse path.
Causes: 1. Check the Fuser Exit Sensor, Reverse Sensor Harness and Connector. 2. Check if the UI message is changed in the Fuser Exit Sensor and the Reverse Sensor operation (EDC Mode). 3. Check the Reverse Motor and Fuser Exit Motor. (EDC Mode).

Code: 01-017
Display: Output bin Full Output bin Full. Remove printed paper
Description: When the tray limit is reached, the out-bin full sensor is on for 600ms.
Causes: 1. Check the Out-Bin Full Sensor. 2. Check if the UI message is changed by the Out-Bin Full Sensor operation. 3. Check the Out-Bin Full Sensor Harness and Connector.

1 2 3 4 >