Description: 1. Paper is not exited from the cassette. 2. Jam-0 occurs if the paper feeds into the printer.
Causes: 1. Check the Solenoid by using Engine Test Mode-Pick up Test. 2. Check if the pad is loose due to bad sealing of the side-pad. 3. Check the surface of the roller-pickup for foreign matter. 4. If the paper feeds into the printer rand Jam 0 occurs, perform Engine Test Mode-Feed Sensor Test.
Description: 1. Recording paper is jammed in front of or inside the fuser. 2. Recording paper is stuck in the discharge roller and in the fuser just after passing through the Actuator-Feed.
Causes: 1. If the recording paper is jammed in front of or inside the fuser. 2. If the recording paper is stuck in the discharge roller and the fuser just after passing through the Actuator- Feed, Feed Actuator may be defective
Description: 1. Recording paper is jammed in front of or inside the fuser. 2. Recording paper is stuck in the discharge roller and in the fuser just after passing through the Actuator-Feed.
Causes: 1. If the paper is completely fed out of the printer, but Jam 2 occurs : Exit sensor is defective. • After the paper is completely discharged, actuator Exit should return to the original position to shut the photo-sensor. Sometimes it takes longer hour than it should and does not return. 2. If the paper is rolled in the Fuser Roller: • This occurs when a Guide claw is broken away or transformed. • It occurs when the Spring of a Guide claw is broken away or transformed. • It occurs when the Heat-Roller or Pressure-Roller is seriously contaminated with the toner. 3. Paper is accordion in the fuser.
Description: Multiple sheets of paper are fed at once.
Causes: 1. Solenoid malfunction(the solenoid does not work properly): Perform Engine Test Mode-Pick up Test. 2. Pad-Friction is contaminated with foreign matter.(oil...) 3. The face of paper is blended.