Description: Controller Logic Fail • A software defect that cannot be ignored was found in the Controller software. • The CPU has rebooted due to the occurrence of an exception.
Remedy: 1. Turn the power OFF and ON. 2. Install a Controller Firmware with the correct version.
Description: Controller NVM Data Defect Any of the following was detected: • The On Board NVM data of the Controller is corrupted. • The On Board NVM of the Controller is not installed. • Any one of the Print Counter has reached its maximum value. • The number of times the NVM can be changed has reached its limit. NOTE: If this Fault reoccurs after performing Data Backup/Restore, perform Data Restore again. (Perform NVM Matching (NVM [621-400]) in the CE Mode.)
Remedy: 1. Turn the power OFF and ON. 2. Perform NVM Initialize in the CE Mode. (Refer to 6.5.2.4 NVM Initialize)
Description: NVM Data Mismatch The verification result between the On Board NVM and the Backup NVM of the Controller is mismatched. (This includes cases where one of the NVM is Blank)
Remedy: 1. Turn the power OFF and ON. 2. Perform NVM Matching (NVM [621-400]) in the CE Mode.
Description: IIT Interrupt Timeout The DMA start trigger when scanning documents cannot be detected for a specified time.
Remedy: 1. Turn the power OFF and ON. 2. Turn OFF the power and check the Flat Cable between the IIT Carriage J700 and the ESS/MCU PWB J420 for open circuits, short circuits, and poor contacts (especially, check whether the Flat Cable was inserted in a skewed manner). 3. Check the ESS/MCU PWB for improper installation (loose screw). 4. Upgrade the Controller Firmware. ADJ 18.2.3 5. If no problem is found, replace the ESS/MCU PWB (PL 18.3).
Description: USB Host Terminal Unknown Device Connection Fail It was detected that something other than a Fax Board is inserted into the USB Host Terminal.
Remedy: 1. Turn the power OFF and ON. 2. Connect the correct Fax PWB (PL 18.5).
Description: Invalid Page Margin During Copy Job, subtracting the amount of edge erase from the section that should have been scanned resulted in a negative value.
Remedy: Change the value for NVM [790-301] (Document Edge Erase Amount) or NVM [790-302] (Document Edge Erase Amount (for ID Card Copy)).
Description: Controller Extension Card NVM Data Defect Any of the following was detected: • The NVM data of the NET I/F Card is corrupted. • The NVM of the NET I/F Card is not installed
Remedy: 1. Turn the power OFF and ON. 2. Check whether the EEPROM is installed. 3. Check the EEPROM for poor contact with the socket. 4. Check the connector ( P/J425) between the ESS/MCU PWB and the NET I/F PWB for poor contact. 5. If no problem is found, replace the following parts in sequence: • NET I/F PWB (PL 18.3) • ESS/MCU PWB (PL 18.3)
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.