Description: The tray 2 jam-access-cover switch, SW105, has detected that the jam-access cover on tray 2 is open.
Remedy: Open the Troubleshooting menu and touch Manual Sensor Test. On the controlpanel display, this switch is represented by the letter “P.” Open and close the tray 2 jam-access door and observe whether the status changes on the control-panel display. If the message persists, verify that the connector J87 on the DC controller is firmly seated. Replace SW105 if necessary.
Description: The tray 2 paper-size-detection switch, SW102, has detected that tray 2 is not installed or that no media is present.
Remedy: 1. Verify that connector J90 on the DC controller is firmly seated. 2. You can use the Manual Sensor Test (Troubleshooting > Manual Sensor Test to test the operation of this switch. Status “S5” indicates that lettersize media is installed in the tray. Status “S3” indicates that A4-size media is installed in the tray. Status “S7” indicates that the tray is not installed in the MFP. Pull the tray out and reinsert it while you observe the status on the control-panel display. If the status does not change, replace SW102.