Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio CL5000 — Trang 4/12

Code: 430

Description: Transfer belt cleaning error Cleaning is operating at the maximum PWM duty value for 60 milliseconds.
Causes: • Short circuit in the transfer belt cleaning unit • Defective high voltage supply board • Defective harness (BCU - high voltage supply board)

Code: 440

Description: Main motor error . The main motor starts or changes speed. - The lock signal does not continue for 1 second within 3 seconds. . The main motor starts. - The lock signal is detected and operation proceeds normally. - The lock signal is interrupted for 1 second.
Causes: • Defective main motor

Code: 460

Description: Temperature sensor error The output is 4.5 V (or higher) or 0.3 V (or lower) for 12 seconds.
Causes: • Short circuit in the temperature sensor • Defective circuit • Defective connector

Code: 461

Description: Humidity sensor error The output is 4.5 V (or higher) or 0.3 V (or lower) for 12 seconds.
Causes: • Short circuit in the humidity sensor • Defective circuit • Defective connector

Code: 480

Description: ID sensor error The ID sensor is being calibrated (process control, step 1) - While the LED is off, the output voltage is 0.5 V or lower.
Causes: • Defective ID sensor • Defective connector

Code: 481

Description: Transfer belt mark detection error The main motor is operating; and the lock signal is detected. - The belt mark sensor signal does not change for 120 milliseconds.
Causes: • Defective main motor • Image transfer belt out of position • Belt mark blurred or absent

Code: 502

Description: 2nd tray error . The tray lift motor turns on. - The top of the paper stack is not detected for 13 seconds. . The tray is set. - The top of the paper stack is detected. - The bottom plate is lowered. - The stack detection is not cleared within 5 seconds. - These steps are repeated 4 times.
Causes: • Defective paper height sensor • Defective tray lift motor

Code: 503

Description: 3rd tray error . The tray lift motor turns on. - The top of the paper stack is not detected for 13 seconds. . The tray is set. - The top of the paper stack is detected. - The bottom plate is lowered. - The stack detection is not cleared within 5 seconds. - These steps are repeated 4 times.
Causes: • Defective paper height sensor • Defective tray lift motor
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie