Description: ID sensor error: Calibration
Before adjustment Vsg_reg<0.5 but Vsg_reg could not be adjusted to the target Vsg_reg = 4.0+-0.2V during process control.
Causes: • ID sensor harness disconnected, loose, defective • ID sensor dirty • ID sensor defective • ITB unit drawer connector dirty
Description: ID Sensor Pattern Maximum Coverage Error 1: K
The amount of toner applied to create the black ID sensor pattern between sheets (SP3101-1 ID Pattern Display - Applied: K) exceeded the maximum threshold of 0.3 mg/cm2 due to an over supply of black toner.
Description: ID Sensor Pattern Maximum Coverage Error 2: M
The amount of toner applied to create the magenta ID sensor pattern between sheets (SP3101-2 ID Pattern Display - Applied: M) exceeded the maximum threshold of 0.7 mg/cm2 due to an over supply of magenta toner.
Description: ID Sensor Pattern Maximum Coverage Error 3: C
The amount of toner applied to create the cyan ID sensor pattern between sheets (SP3101-3 ID Pattern Display - Applied: C) exceeded the maximum threshold of 0.7 mg/cm2 due to an over supply of cyan toner.
Description: ID Sensor Pattern Maximum Coverage Error 4: Y
The amount of toner applied to create the yellow ID sensor pattern between sheets (SP3101-4 ID Pattern Display - Applied: Y) exceeded the maximum threshold of 0.7 mg/cm2 due to an over supply of yellow toner.
Description: ID Sensor Pattern Minimum Coverage Error 1: K
The machine detected 10 times that the amount of toner applied to create the black ID sensor pattern on the drum between sheets (SP3101-1 ID Pattern Display - Applied K) was less than the minimum threshold setting (0.0 mg/cm2). Also, the total time for the operation of the sub hopper clutch (SP3251-1 Tnr Supply Time - Sub Hopper CL: K) was less than or equal to the threshold of 65K ms.
Causes: • Toner shield glass dirty • Development unit defective • Image transfer unit defective
Description: ID Sensor Pattern Minimum Coverage Error 2: M
The machine detected 10 times that the amount of toner applied to create the magenta ID sensor pattern on the drum between sheets (SP3101-2 ID Pattern Display - Applied M) was less than the minimum threshold setting (0.2 mg/cm2). Also, the total time for the operation of the sub hopper clutch (SP3251-2 Tnr Supply Time - Sub Hopper CL: M) was less than or equal to the threshold of 65K ms.
Causes: • Toner shield glass dirty • Development unit defective • Image transfer unit defective
Description: ID Sensor Pattern Minimum Coverage Error 3: C
The machine detected 10 times that the amount of toner applied to create the cyan ID sensor pattern on the drum between sheets (SP3101-3 ID Pattern Display - Applied C) was less than the minimum threshold setting (0.2 mg/cm2). Also, the total time for the operation of the sub hopper clutch (SP3251-3 Tnr Supply Time - Sub Hopper CL: C) was less than or equal to the threshold of 65K ms.
Causes: • Toner shield glass dirty • Development unit defective • Image transfer unit defective
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.