Code :

Code: SC203-51 ... SC203-55
Description: SC203-51 D Ink Supply Error: Head 1 SC203-52 D Ink Supply Error: Head 2 SC203-53 D Ink Supply Error: Head 3 SC203-54 D Ink Supply Error: Head 4 SC203-55 D Ink Supply Error: Head 5
Causes: •X Feeler broken, damaged, or blocked •X Air release solenoid blocked •X Air release solenoid defective •X Ink supply pump or tube defective
Remedy:

Code: SC210
Description: Carriage Horizontal Initialization Error The machine failed to detect the carriage unit at the start position.
Causes: •X Horizontal encoder installed incorrectly (not inserted into the gap of the horizontal encoder sensor) •X Horizontal encoder strip dirty •X Horizontal encoder strip loose, broken, defective •X Horizontal encoder sensor connector loose, broken, defective •X Horizontal encoder sensor defective
Remedy:

Code: SC211-01
Description: Carriage Communication Error The machine detected no response from the carriage unit.
Causes: •X Cycle the machine off/on •X If the problem recurs, check around the HRB on the carriage unit for a loose, broken, or defective connector •X Check around the MCU for a loose broken connector on a harness from the carriage unit.
Remedy:

Code: SC211-02
Description: Carriage Hardware Error The machine detected a hardware error for the carriage unit.
Causes: •X Horizontal motor connector loose, broken, defective •X Horizontal motor blocked by an obstacle •X Horizontal encoder strip dirty •X Horizontal encoder strip loose, broken, defective, or installed incorrectly •X Horizontal encoder sensor connector loose, broken, defective •X Horizontal encoder installed incorrectly •X MCU connector loose, broken, defective •X Horizontal encoder sensor defective •X Horizontal motor defective •X MCU defective
Remedy:

Code: SC212
Description: Head Lift Motor Error The status of the head lift sensor 1 or 2 did not change when the carriage was raised. Within 25 sec.: •X At initialization, head lift sensor 1 did not go OFF and head lift sensor 2 did not go ON. •X When the carriage was raised 1 mm, head lift sensor 1 did not go OFF and head lift sensor 2 did not go OFF. •X When the carriage was raised 2 mm, print head sensor 1 did not go ON.
Causes: •X One or more sensor connector loose, broken, defective •X Lift motor connector loose, broken, defective. •X One or more sensor defective •X Lift motor defective
Remedy:

Code: SC251-02
Description: Waste ink tank full count has exceeded threshold 2
Causes: •X The SC error will continue to display until the unit has been replaced and the count has been cleared.
Remedy:

Code: SC280
Description: Air detection sensor error A problem has occurred at the terminal pin sensor on top of one of the sub tanks, or the maintenance unit is not functioning correctly.
Causes: •X Terminal pin defective •X Maintenance unit defective
Remedy:

< 1 2 3 4 5 6 7 > Last ›