• Code: SC195-00
• Description: Machine serial number error Comparison of the product identification code in the machine serial number (11 digits).
• Causes: The product identification code in the machine serial number (11 digits) does not match.
• Remedy: Re-enter the machine serial number.

• Code: SC230-00
• Description: FGATE*1: Does not turn ON. GPIO*2 has not been asserted, although the specified time (200 ms) elapsed after setting JOB to be started and reaching the FGAT assert time.
• Causes: Control Board (*1)FGATE: Signals used between the controller and the engine in order to send the information about the sub scan length of the page to be printed. (*2)GPIO: A type of input/output terminal
• Remedy: Turn the main power off/on.

• Code: SC231-00
• Description: FGATE*1: Does not turn OFF. GPIO*2 has not been negated, although the specified time (200 ms) elapsed after detecting GPIO*assert and then reaching the expected FGATE negate time.
• Causes: * This is an I/O pin. Such I/O pins can be used for a variety of applications, depending on the setting. (*1)FGATE: Signals used between the controller and the engine in order to send the information about the sub scan length of the page to be printed. (*2)GPIO: A type of input/output terminal
• Remedy: • Turn the main power off/on.

• Code: SC270-00
• Description: Write ASIC communication error • When the engine board could not read the Unique ID of the Writing ASIC properly when starting this machine. • When an Error bit occurred in the communication between the engine board and the Writing ASIC.
• Causes: The unique ID of the write ASIC was not read normally.
• Remedy: • Turn the main power off/on.

• Code: SC277-00
• Description: LEDA communication error The head type data was read three times in succession
• Causes: • Defective LEDA • Defective FFC for LEDA • Defective the engine board (Defective interface b/w Write ASIC - LEDA)
• Remedy: • Turn the main power off/on.

• Code: SC277-10
• Description: LEDA communication error: other The head type data was read three times in succession
• Causes: • Defective engine board (LEDA Power Error: Broken FU7) • Defective harness between PSU – engine board • PSU fault (5V Fuse broken) • Defective controller (Defective engine interface)
• Remedy: • Turn the main power off/on.

• Code: SC302-00
• Description: High voltage output error: Charge unit /Development unit This SC is issued if the engine board detects a short in the power pack 10 times consecutively.
• Causes: Open circuit (+) / Short circuit (-)
• Remedy: • Turn the main power off/on. • Replace the board. • Check the connector connection.

• Code: SC332-00
• Description: Toner supply transfer lock This SC is issued if the error that the toner is not supplied is detected n times consecutively (n: SP2-931-005) on the condition that the toner cartridge is not in end
• Causes: • Overload on the toner transferring part (clogging of toner) • Screw for detecting PCDU does not turn • Detector element (sensor) defective: light leak • Supplying pick does not engage • Defective Supplying clutch • Defective Drive mechanism of screw for supplying toner cartridge
• Remedy: • Turn the main power off/on.