Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio SP8100DN — Trang 9/15

Code: 733

Description: Finisher lower tray lift motor error
The stack height sensor did not activate within 15 sec. after the lower tray lift motor turned on.
Causes: • Lower tray lift motor connector or harness loose, broken, defective • Lower tray lift motor defective or overloaded due to an obstruction • Upper stack height sensor connector or harness loose, broken, defective • Upper stack height sensor defective • Lower tray lower limit sensor connector or harness loose broken, defective • Lower tray lower limit sensor defectivec

Code: 734

Description: Finisher lower tray shift motor error
The lower tray did not reach the home position within 1.25 sec. after the lower tray shift motor turned on.
Causes: • Lower tray shift motor connector or harness loose, broken, defective • Lower tray shift motor defective or overloaded due to an obstruction • Lower tray shift sensor harness or connector loose, broken, defective • Lower tray shift sensor defective

Code: 818

Description: Watchdog error
The bus is being held by another device, or a CPU-device infinite loop has occurred. A module that the watchdog is monitoring has not closed properly at the conclusion of its task, or the module cannot continue processing.
Causes: • System program defective; switch off/on, or change the controller firmware if the problem cannot be solved • Controller board defective • Controller option malfunction

Code: 819

Description: Fatal kernel error
Due to a control error, a RAM overflow occurred during system processing. One of the following messages was displayed on the operation panel.
Causes: • System program defective • Controller board defective • Optional board defective • Replace controller firmware

Code: 820

Description: Self-Diagnostic Error: CPU
The central processing unit returned an unexpected error during the self-diagnostic test.
Causes: • Controller board defective • Firmware defective • Update firmware Note: This SC also logs one of 47 hex codes (0001 to 4005). However, the recovery procedure is the same in each case.

Code: 821

Description: Self-diagnostic error 2: ASIC
The Write & Verify check of the ASIC returned an error. Note: The main ASIC module on the controller board controls the bus of the ROM device..
Causes: • Replace the controller board

Code: 822

Description: Self-diagnostic error 3: HDD
Causes: • HDD defective • HDD harness disconnected, defective • Controller board defective

Code: 823

Description: Self-diagnostic Error: NIC
The network interface board returned an error during the self-diagnostic test.
Causes: • Network interface board defective (replace the controller board) • Controller board defective
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie