Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio SP8100DN — Trang 2/15

Code: 335

Description: Polygon motor error 1: On timeout
The XSCRDY signal did not go LOW (Active) within 10 sec. after the polygon motor was turned on.
Causes: • Polygon motor drive board I/F harness loose, disconnected, or damaged • Polygon motor drive board defective • Polygon motor defective

Code: 336

Description: Polygon motor error 2: Off timeout
The XSCRDY signal did not go HIGH (Inactive) within 3 sec. after the polygon motor was turned off.
Causes: • Polygon motor drive board I/F harness loose, disconnected, or damaged • Polygon motor drive board defective • Polygon motor defective

Code: 337

Description: Polygon motor error 3: XSCRDY signal error
The XSCRDY signal did not go HIGH (Inactive) after the polygon motor had been rotating normally for 200 ms.
Causes: • Polygon motor drive board I/F harness loose, disconnected, or damaged • Polygon motor drive board defective • Polygon motor defective

Code: 338

Description: Polygonal Mirror Motor Error 4: Unstable Timeout
The XSCRDY signal was detected LOW) (Active) after the polygonal mirror motor switched on, but the signal was not detected LOW after 1 sec., and was not detected after another 500 ms.
Causes: • I/F harness of the polygonal mirror motor disconnected or defective. • Polygonal mirror motor or polygonal mirror motor drive board defective.

Code: 350

Description: ID sensor pattern test error
One of the following ID sensor output voltages was detected twice consecutively when checking the ID sensor pattern. 1. Vsp greater/equal 2.5V 2. Vsg less than/equal 2.5V 3. Vsp = 0V 4. Vsg = 0V
Causes: • ID sensor defective • ID sensor harness or connector loose, broken, defective • IOB defective • HVPS board defective • ID sensor dirty

Code: 351

Description: ID sensor Vsg measurement error
When the ID sensor was checked twice, the ID sensor output voltage was 5.0V while the PWM signal input to the ID sensor was 0.
Causes: • ID sensor connector or harness loose, broken, or defective • ID sensor defective • IOB defective • HVPS defective • ID sensor dirty

Code: 352

Description: ID sensor pattern edge detection error
The ID sensor pattern edge voltage was not equal to 2.5 V and two samplings within 800 ms.
Causes: • ID sensor connector or harness loose, broken, or defective • ID sensor defective • IOB defective • HVPS defective • ID sensor dirty

Code: 353

Description: ID sensor, LED current abnormal at initialization
One of the following ID sensor output voltages is detected at ID sensor initialization. • Vsg less than 4.0V when the maximum PWM input (255) was applied to the ID sensor. • Vsg exceeded 4.0V when the minimum PWM input (0) is applied to the ID sensor.
Causes: • ID sensor connector or harness loose, broken, or defective • ID sensor defective • IOB defective • HVPS defective • ID sensor dirty
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie