Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio SP8100DN — Trang 3/15

Code: 354

Description: ID sensor timeout abnormal at adjustment
Vsg fell out of the adjustment target range (4.0 +- -0.2V) at the start of Vsg checking after 20 sec.
Causes: • ID sensor connector or harness loose, broken, or defective • ID sensor defective • IOB defective • HVPS defective • ID sensor dirty

Code: 390

Description: TD sensor error: Abnormal measurement
The TD sensor output voltage was less than 0.5V, or more than 4.8V 10 consecutive times during copying. -or- The output was less than 2.5V after a new PCDU was installed.
Causes: • TD sensor connector or harness loose, broken, defective • TD sensor defective • IOB) defective • Toner supply defective (confirm that the toner seal strip has been removed from toner cartridge)

Code: 391

Description: TD sensor error: Auto adjust error
During automatic adjustment of the TD sensor, output voltage was less than 1.8V, or more than 4.8V during TD sensor initial setting
Causes: • TD sensor connector or harness loose, broken, defective • TD sensor defective • IOB defective • Toner supply defective (confirm that the toner seal strip has been removed from toner cartridge)

Code: 395

Description: Development output abnormal
A development bias leak signal was detected. High voltage output to the development unit exceeded the upper limit (65%) for 60 ms.
Causes: • Poor connection at the development bias terminal • HVPS connectors or harnesses loose, broken, defective • HVPS defective

Code: 401

Description: Transfer roller leak detected
A transfer roller current leak signal is detected.
Causes: • HVPS board defective • Poor cable connection or defective cable • Transfer connector defective

Code: 402

Description: Transfer roller open error
The transfer roller current feedback signal is not detected.
Causes: • HVPS defective • Transfer connector cable defective • Transfer connector defective • Poor PCU connection

Code: 403

Description: Transfer belt position sensor error
The transfer belt position sensor did not activate after the transfer belt contact clutch was switched on twice and rotated once.
Causes: • Main motor malfunction • Transfer belt contact clutch defective • Transfer belt position sensor harness or connector loose, broken, defective • Transfer belt position sensor defective

Code: 405

Description: Transfer belt error
The transfer belt did not move away from the drum during the ID sensor pattern check.
Causes: • Main motor malfunction • Transfer belt contact clutch defective • Transfer belt position sensor harness or connector loose, broken, defective • Transfer belt position sensor defective
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie