Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh D045 MPC1800 PG-C2

Code: 101-001

Description: Exposure lamp error Shading at AGC
The shading data peak does not reach the specified threshold (64/255 degit) when the machine executes the shading at initialization.
Causes: • Defective exposure lamp • Defective lamp stabilizer • Defective exposure lamp harness
Remedy: 1. Replace the exposure lamp. 2. Replace the lamp stabilizer. 3. Replace the exposure lamp harness.

Code: 101-002

Description: Exposure lamp error Shading at scanning
The shading data peak does not reach the specified threshold (64/255 degit) when the machine executes the shading at scanning.
Causes: • Defective exposure lamp • Defective lamp stabilizer • Defective exposure lamp harness
Remedy: 1. Replace the exposure lamp. 2. Replace the lamp stabilizer. 3. Replace the exposure lamp harness.

Code: 120

Description: Scanner home position error 1
The scanner home position sensor does not detect the “OFF” condition during operation.
Causes: • Defective scanner motor drive board • Defective scanner motor • Defective home position sensor • Defective harness
Remedy: 1. Replace the scanner motor drive board. 2. Replace the scanner motor. 3. Replace the scanner HP sensor. 4. Replace the harness.

Code: 121

Description: Scanner home position error 2
The scanner home position sensor does not detect the “ON” condition during operation
Causes: • Defective scanner motor drive board • Defective scanner motor • Defective home position sensor • Defective harness
Remedy: 1. Replace the scanner motor drive board. 2. Replace the scanner motor. 3. Replace the scanner HP sensor. 4. Replace the harness.

Code: 141

Description: Black level detection error
The black level cannot be adjusted within the target value during the zero clamp after the AGC.
Causes: • Defective SBU • Defective harness
Remedy: 1. Replace the harness. 2. Replace the SBU. 3. Replace the BICU.

Code: 142

Description: White level detection error
The white level cannot be adjusted within the target value during the zero clamp after the AGC.
Causes: • Defective SBU • Defective harness
Remedy: 1. Replace the exposure lamp. 2. Replace the lamp stabilizer. 3. Replace the harness. 4. Replace the SBU.. 5. Replace the BICU

Code: 144-001

Description: SBU connection error
The SBU connection cannot be detected at power on or recovery from the energy save mode.
Causes: • Insufficient power supply for SBU • Defective SBU • Defective harness • Defective detection port on the BCU
Remedy: 1. Replace the harness. 2. Replace the SBU. 3. Replace the BICU.

Code: 144-002

Description: SBU serial communication error
The unusual register value from the SBU is detected more than three times at power on or recovery from the energy save mode.
Causes: • Insufficient power supply for SBU • Defective SBU • Defective harness • Defective detection port on the BCU
Remedy: 1. Replace the harness. 2. Replace the SBU. 3. Replace the BICU.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie