Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi HP Latex 3000 — Trang 31/42

Code: 43.01.00:01

Description: Vacuum blower not working in diagnostic test. Call support.
Causes: Vacuum tachometer is not giving feedback signal.
Remedy: 1. Run diagnostic. 2. Check connections. 3. Replace part.

Code: 43.02.00:04

Description: No feedback from the vacuum PCA. Check that substrate behavior in the print zone is OK. Run diagnostic when the job finishes.
Causes: a. Connections vacuum PCA failure b. Power management
Remedy: 1. Check connections. 2. Check e-box and e-cabinet. 3. Replace vacuum PCA.

Code: 43.03.00:04

Description: No feedback from the vacuum pressure sensor. Check that substrate behavior in the print zone is OK. Run diagnostic when the job finishes.
Causes: Connections pressure sensor vacuum PCA failure
Remedy: 1. Check connections. 2. Check pressure sensor EE and air connections. 3. Replace the sensor.

Code: 43.03.00:30

Description: Vacuum out of range. Run diagnostics. If the problem persists, call your service representative.
Causes: a. Air path open b. Pressure sensor inlet disconnected c. Power problem d. Pump problem
Remedy: 1. Run diagnostic. 2. Check connections. 3. Check EE and air connections.

Code: 43.03.00:83

Description: Vacuum sensor calibration fail. Check that substrate behavior in the print zone is OK. Run diagnostic when the job finishes.
Causes: a. Calibration process failure b. Cabling c. Sensor malfunction d. Vacuum pump failure
Remedy: 1. Repeat calibration process. 2. Check cabling and wiring. 3. Replace the sensor. 4. Replace the vacuum pump.

Code: 46.00.01:83 ... 46.00.01:83

Description: Primer X not calibrated. Run subsystem diagnostic. If the problem persists, call your support representative.
Causes: No value or zero read from NVM
Remedy: Run primer calibration.

Code: 46.01.01:01 ... 46.01.07:01

Description: Primer X signal failure. Run subsystem diagnostic. If the problem persists, call your support representative.
Causes: Current signal lost or current measure below reference threshold
Remedy: 1. Check connections. 2. Check carriage interconnect PCA 1 or 2, depending on the primer position reported. 3. Check the primer pump.

Code: 46.02.01:06 ... 46.02.07:06

Description: Primer X leakage detected. Reset primer latch and/or check o-rings. If the problem persists, run the subsystem diagnostic.
Causes: Current consumption measured below calibration value
Remedy: 1. Check primers, looking for leaks. 2. Check latches and o-rings. 3. Run subsystem diagnostic.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie