Danh mục sản phẩm

Code :

Code: 008-153
Description: Feed Jam 1(Early Feed Jam)
Causes: Paper is fed to Regi too fast. Check paper set, dirt or defect of REGI. Sensor

Code: 008-155
Description: Regi Sensor On Jam
Causes: Regi Sensor is On while Warming up.Scrap of paper is left, dirt or defect of REGI. Sensor

Code: 008-156
Description: Regi Sensor Off Jam
Causes: Paper is not fed from Reg position to Fuser position within the specified time. Slip of REGI. Roll, wear, fail of rotation Breakage failure of Fuser drive gear Dirt or defect of REGI. Sensor

Code: 008-176
Description: Tray 1 Regi Sensor On Jam
Causes: Regi Sensor doesn' t become On though the specified time is passed after starting Tray1 Feed Slip of Tray 1 Feed Roll, wear, fail of rotation Clutch Assy PH(TRAY1) defects Dirt or defect of REGI. Sensors

Code: 008-180
Description: Dup Miss Feed Jam
Causes: Sensor DUP doen' t become ON when Duplex feeding. Slip of Feed Roll, wear, fail of rotation Dirt or defect of Sensor DUP

Code: 008-314
Description: I/F trouble between HVPS/MCU PWB-DM
Causes: Disconnect Duplex Unit after powering on Check the connection of Duplex Unit and machine

Code: 009-413
Description: Toner Black 1 Near Empty
Causes: Black Toner is almost empty. (No service work) Change drum/toner cartridge as needed.

Code: 009-909
Description: EP Cartridge Type Missmatch
Causes: ID in NVM of IOT machine and ID of drum/toner cartridge are different. Set the correct drum/toner cartridge.

‹ First < 4 5 6 7 8 9 10 > Last ›

0