• Code: 009-910
• Description: EP Cartridge Not Installed
• Causes: The drum/toner cartridge is not set. Set the drum/toner cartridge correctly.

• Code: 010-105
• Description: Fuser Exit Sensor On Jam
• Causes: Fuser Exit Sensor doesn’ t detect paper from REGI. Clutch ON after specific time passed. Slip of Feed Roll, wear, fail of rotation Defect of Fuser Exit Sensor Disconnection of wires from Fuser Exit Sensor J4247-1 to MCU PWB J11-10 or loose connection

• Code: 010-106
• Description: Fuser Exit Sensor Off Jam
• Causes: Paper doesn’ t go through Fuser Exit Sensor though the specific time passed after REGI. Sensor go through. Check whether paper is not rolled to Heat Roll. Defect of Fuser Exit Sensor Short out the wires from Fuser Exit Sensor J159-1 to MCU PWB J15B3.

• Code: 010-112
• Description: Exit Out Early Jam
• Causes: Fuser Exit Sensor becomes OFF in shorter time than specified after Fuser Exit Sensor detected the top of paper. (Turning to OFF is too early.) Check whether paper is not rolled to Fuser Exit Roll.

• Code: 010-128
• Description: Duplex Pre Regi Sensor On Jam
• Causes: Paper comes to Regi from Sensor DUP too fast. Dirt or defect of Sensor DUP

• Code: 010-132
• Description: Duplex Path 1 Sensor On Jam
• Causes: Paper is not ejected from Sensor DUP within the specific time, or Sensor DUP is On while Warming up. Slip of Feed Roll, wear, fail of rotation, scrap of paper is left Dirt or defect of Sensor DUP

• Code: 010-164
• Description: Regi.SNR On Jam <Dup Miss Feed Jam>(not wait)
• Causes: Paper doesn’ t come to Reg from Sensor DUP within the specific time. Slip of Feed Roll, wear, fail of rotation Dirt or defect of Sensor DUP

• Code: 010-347
• Description: <OCT failure> Offset Fail (OCT)
• Causes: Fail to communication with machineCheck the connection to the machine, and replace PWBA OCT if it is no problem.