Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MPW3601 — Trang 3/13

Code: 460

Description: DC Separation Corona Output Error A dc separation feedback voltage of less than 0.5 V was detected after more than 200 ms.
Causes: • High voltage cable disconnected, damaged • T/S power pack defective
Remedy:

Code: 508

Description: Cutter Error The left and right cutter HP sensors remained on or off more than 2 sec.
Causes: • HP sensors on the left and right side loose, disconnected, defective • Cutter motor harness damaged, defective • Cutter motor defective Note: Paper can be fed from the bypass table if the roll feeder or paper cassette is not operating.
Remedy:

Code: 520

Description: Main Motor Error After the motor started, the main motor lock signal remained HIGH for 5 sec.
Causes: • Physical obstruction blocking motor • Motor harness damaged, defective • Motor defective
Remedy:

Code: 521

Description: Drum Motor Error After the motor started, the drum motor lock signal remained HIGH for 5 sec.
Causes: • Physical obstruction blocking motor • Motor harness damaged, defective • Motor defective
Remedy:

Code: 522

Description: Fusing Unit Drive Motor Error After the motor started, the fusing motor lock signal remained HIGH for 5 sec.
Causes: • Physical obstruction blocking motor • Motor harness damaged, defective • Motor defective
Remedy:

Code: 530

Description: Fusing Unit Ventilation Fan Error After the motor started, the fan motor lock signal remained HIGH for 5 sec.
Causes: • Physical obstruction blocking motor • Motor harness damaged, defective • Motor defective
Remedy:

Code: 541

Description: Fusing Thermistor Errors The thermistor measured the hot roller temperature every 1 sec. for 30 sec. and the temperature remained below 5C (54F).
Causes: • Thermistor positioned incorrectly • Thermistor cable loose, disconnected, damaged • Thermistor defective
Remedy:

Code: 542

Description: Fusing Temperature Warm-up Error The hot roller did not reach the ready temperature within 4 min. 30 sec. after power on. -or- The hot roller did not reach 100°C within 130 sec. after power on.
Causes: • Fusing lamp connections loose, broken, defective • Fusing lamp defective • Thermistor not touching the hot roller • Thermistor defective • MCU defective
Remedy: The ready temperature is determined by the state of the machine at recovery: • Ready Temp. = Target Fusing Temp. (if power on or recovery starts when the hot roller is 80°C or higher). • Ready Temp. = Target Fusing Temp. – 10°C (SP1105-1 default) if power on or recovery starts when the hot roller is less that 80°C. • Ready Temp. = Target Fusing Temp. – 20°C (SP1937-3 default) if power on or recovery starts with pressure roller inching control on.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie