Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MPW3601 — Trang 12/13

Code: SC641

Description: Engine-Controller Communication Error: No Response CTL There was no response to a frame sent from the controller board to the engine.
Causes: • Cycle the machine off/on.
Remedy:

Code: SC954

Description: Printer Image Setting Error The IPU did not issue the signal required to start image processing for the printing mode within 60 s after the paper stops for registration.
Causes: • Software defective • Replace the software (all firmware modules). • SIPU defective
Remedy:

Code: SC965

Description: Print Start Error During print processing, another command to start printing was received.
Causes: • Printer firmware defective • Update printer firmware
Remedy:

Code: SC967

Description: Image write start error The paper stopped at the registration sensor and roller for buckle adjustment but the signal to start image writing was not received within 60 sec.
Causes: • Printer firmware defective • Update printer firmware • Check the connections between the LPH sections (x3) and the VDB • LPH defective • VDB defective • MCU defective
Remedy:

Code: SC984

Description: Print image data send error No data was sent within 1 sec. after the print image data stream started.
Causes: • Harness from IPU to controller board loose, broken, defective • SIPU defective
Remedy:

Code: SC990

Description: Software error 1 CTL The software performs an unexpected function and the program cannot continue.
Causes: • Firmware defective: re-boot • Update firmware
Remedy: 1. Execute SP7403 or print an SMC Report (SP5990) to read the history of the 10 most recent logged errors. 2. If you press [0] on the operation panel with the SP selection menu displayed, you will see detailed information about the recently logged SC990 or SC991 errors, including the software file name, line number, and so on. (1) above is the recommended method, because another SC could write over the information for the previous SC.

Code: SC991

Description: Software error 2 CTL The software performs an unexpected function. However, unlike SC990, recovery processing allows the program to continue.
Causes: • Software defective, re-boot
Remedy: 1. Execute SP7403 or print an SMC Report (SP5990) to read the history of the 10 most recent logged errors. 2. If you press [0] on the operation panel with the SP selection menu displayed, you will see detailed information about the recently logged SC990 or SC991 errors, including the software file name, line number, and so on. (1) above is the recommended method, because another SC could write over the information for the previous SC.

Code: SC992

Description: Erratic SC error
Causes: There was an unusual operation by the software because of: • An incorrect argument in the program. • An incorrect internal parameter. • Work memory not sufficient. • An error occurred that could not be detected by other SC codes.
Remedy: • Turn the main power switch off/on. • Go into the SP mode. Do SP7901 to display details about SC992 (software file name, line number, and variable), and inform your supervisor of the results.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie