Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MPW3601 — Trang 5/13

Code: 559

Description: Fusing paper jam errors Three consecutive paper jam errors occurred in the fusing unit. Note: This SC code is not issued unless SP1159 is switched on.
Causes: • Paper jam in fusing unit • Pick-off pawl defective • Paper scraps in fusing unit • Exit sensor defective
Remedy:

Code: 561

Description: Pressure roller end thermistor error 1. During the hot roller temperature control sequence, or while the hot roller and pressure roller were rotating, the center thermistor on the pressure roller returned a digital reading of more than 3.3V.
Causes: • Pressure roller center thermistor not positioned properly • Pressure roller center thermistor connector loose, broken, defective • Pressure roller end thermistor defective • MCU defective
Remedy:

Code: 563

Description: Pressure roller end thermistor error 2. During the hot roller temperature control sequence, the end thermistor on the pressure roller returned a digital reading of less than 0.2V.
Causes: • Pressure roller end thermistor connector loose • Pressure roller end thermistor short circuit, defective • MCU defective
Remedy:

Code: 632

Description: Key/card counter device error 1 CTL After 1 data frame is sent to the device, an ACK signal is not received within 100 ms, and is not received after 3 retries.
Causes: • Serial line from the device to the main machine is unstable, disconnected, or defective
Remedy:

Code: 633

Description: Key/card counter device error 2 CTL During communication with the device, the MCU received a break (Low) signal.
Causes: • Serial line from the device to the main machine is unstable, disconnected, or defective
Remedy:

Code: 634

Description: Key/card counter device error 3 CTL The backup battery of the counter device RAM is low.
Causes: • RAM backup battery exhausted • Counter device defective
Remedy:

Code: 635

Description: Key/card counter device error 4. After installation of the device a message alerts user to a battery voltage abnormal error.
Causes: • Device control board defective • Device control board backup battery defective
Remedy:

Code: 636-1

Description: SD Card Error CTL Expanded authentication module error
Causes: • No expanded authentication module in the machine. (Install expanded authentication module.) • Expanded authentication module file is corrupted. • Expanded authentication module SD card is damaged. • No DESS module in the machine. (Install DESS module.)
Remedy:
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie