• Code: 231-04
• Description: FGATE: Does not turn OFF Y
  GPIO has not been negated, although the specified time (200 ms) elapsed after detecting GPIO*assert and then reaching the expected FGATE negate time. * This is an I/O pin. Such I/O pins can be used for a variety of applications, depending on the setting.
• Causes: • Control Board • Engine Board
• Remedy:

• Code: 270-00
• Description: Write ASIC communication error
  • When the Engine Board could not read the Unique ID of the Writing ASIC properly when starting this machine. • When an Error bit occurred in the communication between the Engine Board and the Writing ASIC.
• Causes: The unique ID of the write ASIC was not read normally.
• Remedy:

• Code: 277-01
• Description: LEDA communication errore Board Bk
  The head type data was read three times in succession
• Causes: • LED Head error • Harness Error
• Remedy: • Turn the power OFF and then ON. • Replace the LED Head

• Code: 277-02
• Description: LEDA communication errore Board C
  The head type data was read three times in succession
• Causes: • LED Head error • Harness Error
• Remedy: • Turn the power OFF and then ON. • Replace the LED Head

• Code: 277-03
• Description: LEDA communication errore Board M
  The head type data was read three times in succession
• Causes: • LED Head error • Harness Error
• Remedy: • Turn the power OFF and then ON. • Replace the LED Head

• Code: 277-04
• Description: LEDA communication errore Board Y
  The head type data was read three times in succession
• Causes: • LED Head error • Harness Error
• Remedy: • Turn the power OFF and then ON. • Replace the LED Head

• Code: 332-01
• Description: Toner supply feed lock Bk
  Under the condition that the Toner Cartridge has not reached the end, an error that no toner is supplied has been detected over n times in succession. n: The value was set at SP3-131-015.
• Causes: • Disconnected or broken Solenoid: Upper cover. (Failed to open the toner supply shutter) • Disconnection of Toner Supply Clutch • Failed PCDU. (Toner leak) • Toner clogging
• Remedy: • Check the connector connection or check for broken wire. • Replace the Solenoid: Upper Cover • Replace the PCDU • Replace the Toner Cartridge.

• Code: 332-02
• Description: Toner supply feed lock C
  Under the condition that the Toner Cartridge has not reached the end, an error that no toner is supplied has been detected over n times in succession. n: The value was set at SP3-131-015.
• Causes: • Disconnected or broken Solenoid: Upper cover. (Failed to open the toner supply shutter) • Disconnection of Toner Supply Clutch • Failed PCDU. (Toner leak) • Toner clogging
• Remedy: • Check the connector connection or check for broken wire. • Replace the Solenoid: Upper Cover • Replace the PCDU • Replace the Toner Cartridge.