Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Roland MDX540

Code: FE:10

Description: Z Limit SW can not be detected.
Causes: Z Limit SW is not attached correctly or defective. There is a bad contact or a cut-line in the cable.

Code: FE:11

Description: A Limit SW can not be detected.
Causes: A Limit SW is not attached correctly or defective. There is a bad contact or a cut-line in the cable.

Code: FE:12

Description: Phase signal or encoder of the X Motor becomes out of order in the initial operation.
Causes: X Motor is defective. There is a bad connection or cut-line in the cable.

Code: FE:13

Description: Phase signal or encoder of the Y Motor becomes out of order in the initial operation.
Causes: Y Motor is defective. There is a bad connection or cut-line in the cable.

Code: FE:14

Description: Phase signal or encoder of the Z Motor becomes out of order in the initial operation.
Causes: Z Motor is defective. There is a bad connection or cut-line in the cable.

Code: FE:15

Description: Phase signal or encoder of the A Motor becomes out of order in the initial operation.
Causes: A Motor is defective. There is a bad connection or cut-line in the cable.

Code: FE:16

Description: EEPROM on the Main board is not operating correctly.
Causes: Setting cannot be written in the EEPROM on the Main board.

Code: FE:17

Description: ATC fails to grab a tool.
Causes: ATC fails to grab a tool. Tool Hold Sensor is not operating correctly.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie