Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi HP DesignJet T7200 — Trang 14/18

Code: 53.1:11

Description:
Causes: Media Sensor cable does not seem to be connected
Remedy: • Check that the Media Sensor cable is not damaged. • Check that the Media Sensor cable is correctly connected to the Interconnect PCA.

Code: 53:10

Description: Media Sensor
Causes: Media Sensor error
Remedy: • Check that the Media Sensor cable is not damaged and is connected correctly to the Interconnect PCA. • Replace the Media Sensor

Code: 55:10

Description: Line Sensor
Causes: Line Sensor communication failure
Remedy: • Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power cord and turn on the printer. • Replace the Line Sensor

Code: 56:01

Description: Paper Encoder Sensor
Causes: Incorrect readings from paper encoder
Remedy: • Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power cord and turn on the printer. • Perform Paper Drive diagnostics. • Replace the Encoder Disc and Sensor

Code: 56:10

Description: Paper Encoder Sensor
Causes: Paper Encoder calibration failed
Remedy: • Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power cord and turn on the printer. • Perform Paper Drive diagnostics. • Replace the Encoder Disc and Sensor

Code: 59.1:09

Description: Incompatible parts
Causes: Two electrical parts have been replaced at the same time
Remedy: Replace one part at a time, and restart the printer before replacing another.

Code: 59.2:00

Description: Incompatible parts
Causes: An unsupported or reused part has been installed
Remedy: Install only new parts recommended by HP for this printer.

Code: 60.1:11

Description: Initialization
Causes: Initialization error
Remedy: • Turn the power off at the rear of the printer and disconnect the power cord. • Check that the printer is properly connected in all other respects. In particular, check that the tag cable is well connected to the ISS Top PCA, and the ISS Top PCA is well connected to the PrintMech PCA. • Reconnect the power cord and turn on the printer. • If the error persists, contact HP.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie