• Code: 06:03
• Description: NVM file has bad CRC.
• Remedy: • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • If the System Error continues, replace the Hard Disk Drive .

• Code: 06:10
• Description: Main NVM failure - not detected, read/write failed or readback error.
• Remedy: • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • If the System Error continues, replace the Hard Disk Drive .

• Code: 07:10
• Description: Aerosol Fan driver burnt.
• Remedy: • Replace the Interconnect PCA . • If the System Error continues, replace the Sausalito PCI PCA . NOTE: Replace one part at a time and check if the error has cleared before replacing another.

• Code: 08:11
• Description: Problem with communication between the Front Panel, the Formatter and the HDD.
• Remedy: • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Check that the Front Panel cable is not damaged and is correctly connected to the Front Panel and to the Interconnect PCA. • Check that the Memory Module is installed correctly. • Check that the cables between the Interconnect PCA and the Main PCA are not damaged and are correctly connected. • Check that the cables between the Hard Disk Drive and the Power Supply Unit and the Main PCA are not damaged and are correctly connected. • Check that the cable between the Power Supply Unit and the Main PCA is not damaged and is correctly connected. • Check that the Printer has the latest Firmware version. If not, update the Firmware to the latest version. • Replace the Hard Disk Drive . • Replace the Main PCA . • Replace the Memory Module . • Replace the Interconnect PCA . • Replace the Front Panel . • Replace the Sausalito PCI PCA.

• Code: 11:10
• Description: Trailing Cable does not seem to be connected.
• Remedy: • Check that the Trailing Cable is not damaged. • Check that the Trailing Cable is correctly connected to the Carriage PCA, Interconnect PCA and to the Sausalito PCI PCA. • Replace the Sausalito PCI PCA . • Replace the Ink Supply Tubes and Trailing Cable .NOTE: If the Ink Supply Tubes are to be replaced, the Ink Cartridges need to be checked beforehand to see if they are capable of purging the new tubes, if they are not, new Ink Cartridges must also be sent with the parts to be replaced. To check the Ink Cartridges go to . • Replace the Carriage PCA .

• Code: 21:03
• Description: Service Station servo shutdown.
• Remedy: • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • If the System Error continues, replace the Service Station . • Replace the PrintMech PCA . • Replace the Interconnect PCA .

• Code: 21:10
• Description: Fault has been detect in the area of the Service Station.
• Remedy: • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Make sure that the Service Station path is clear. Remove any visible obstacles (e.g. foam from the printerfs packaging, screws, plastic parts, etc...) restricting the movement of the Service Station. • If the System Error continues, replace the Service Station .

• Code: 21:13
• Description: Problem with the Service Station.
• Remedy: • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Make sure that the Service Station path is clear. Remove any visible obstacles (e.g. screws, plastic parts, etc...) restricting the movement of the Service Station. • If the System Error continues, replace the Service Station .