Code :

Code: 94:08
Description: Color Calibration failed: This errror message is briefly displayed after failing to calibrate.
Remedy: • There are a few types of media which will cause the calibration to fail if used: • Semi-translucent and transparent media (film). • Media that is not completly flat with a Satin finish will cause the light to reflect in different directions. • Perform Color Sensor Test Ë • Check the connections of the cables between the Spectrophotometer and the Carriage Assembly. • Replace Color Sensor • Replace Carriage PCA

Code: 94:08.1
Description: The color calibration failed because the Spectrophotometer measured a value L*less than 100. This error is not displayed on the Front Panel, but is still logged within the warning error list.
Remedy: • When this error is displayed there is a high probability that the embedded Spectrophotometer is dirty and needs to be replaced, perform the Spectrophotometer test to confirm this • Check the cable connections between the Carriage PCA and the Spectrophotometer. • Replace Color Sensor • Replace Carriage PCA

Code: 97:01
Description: The Automatic Paper Advance Calibration failed.
Remedy: • There are a few types of media which will cause the calibration to fail if used: • Semi-translucent and transparent media (film) • Low quality 3rd party media will cause the printed dots to diffuse. • Use HP Media to perform the calibration. • Perform the manual advance calibration (Ink -> image quality maintenance -> Paper advance calibration -> Adjust Paper advance), moving from 0 to 100% represent to an advance of the media by 1.5mm per meter. • Check cable connections between the densitophotometer/line sensor and the Carriage PCA. • Replace the Line Sensor

Code: 98:02
Description: (this error code will be logged in the system but will not actually appear on the Front Panel) Switching to lower performance due to Printhead quality.
Remedy: • Perform Printhead alignment.